Steel rubber products has them. They are difficult to install. I replaced them in my 66 W300. They come with new clips for mounting.
Forum: Dodge Sweptline Truck General Discussion

I have a 1966 W300. The dashboard has numerous holes cut in for fire dept add ins. If anyone has a decent dash they would like to part with I would like to purchase it so I could paint and replace mine with it. finesvilleflats@ptd.net. thanks.
Forum: Dodge Sweptline Truck General Discussion

I know someone out there has replaced the seats in thier sweptline with a more modern/comfortable seat. What would be a clean set to bolt into a 67 W300 without any alterations? Would a set out of a late model Dodge with a center storage console fit? Single seats or a Bench seat? Leather or cloth or maybey that material that is endangered, the nauga-hide? Thanks for the help.
Forum: Dodge Sweptline Truck General Discussion

I have rebuilt the carb, which was a mess inside. After putting it back on it started up and ran well-at idle only. It would not increase in RPM. I thought that there was not enough fuel pressure and went through that system, but found it OK. Well, to make a long story short, the condenser failed. It was new, only in the truck for about two weeks. THis problem drove me nuts! Anyhow thanks
Forum: Dodge Sweptline Truck General Discussion

It is a poly. The top of the valve cover has two bolts in it for removal. When I rebuilt the 6 cylinder in my B1 I had the machine shop put in hardened seats. I still put the Lucas fuel additive in when I get gas and I put Lucas in this truck also. I currently have the carb off soaking. I ordered a kit and I am going to rebuild it. I am with you on the Iron trucks instead of plastic.
Forum: Dodge Sweptline Truck General Discussion

John, the linkage on the top of the carb for the Acc pump was disconnected. I fixed that. There are no adjustments on any of the rocker arms so I have to think that the lifters are hydraulic. I know that it should have solids in it and it is the original motor but it seems that there are hydraulic lifters in this motor. The truck is titled as and looks like a 66 but the ser # info says it is
Forum: Dodge Sweptline Truck General Discussion

I have a 66 W300. The truck sat for a long time before coming back to life. The motor was running fine, but with a noisey lifter. Now it starts and idles but when you step on the gas it bogs, sometimes spits in the carb or the exhaust. New plugs points wires cap roter and adjustments are good. Oil and filter change. No smoke or internal engine noise when running. Question! Could it be that
Forum: Dodge Sweptline Truck General Discussion