1961-71 Dodge Sweptline Truck Forum

Sweptline Showcase

Sponsored Links

I may **soon change out my 67 D100 (swb) 4 speed for a 727 I have a 68 D200 which is about to be recycled. If you tell me the transmission crossmember will bolt into my 67 D100frame I shall unbolt it off 3/4 ton frame. Gordo ** whenever edited my error of D300 Edited 1 time(s). Last edit at 07/26/2 
Re: Will it fit?
Posted by: little doug (50.37.133.---)
Posts: 460
Date: July 23, 2011 03:38PM

LOL.

Here is my take on it.

If you want,you could just use the lower part of the 69 cross member that bolts to the frame. I have had good results drilling the bottom of the frame rail using a 1/2" drill atop a floor jack.It takes a bit of practice,but alleviates the strain of pushing up on the drill.It also gets you out from under those hot shavings.

I have a set of spanners for your 67s front X member that you could have for the cost of shipping,if you go this route...

Navigate: Previous MessageNext Message
Options: ReplyQuote


Subject Views Written By Posted
Will it fit? 1136 Gordo 07/22/2011 02:27PM
Re: Will it fit? 460 little doug 07/22/2011 11:03PM
Re: Will it fit? 441 Gordo 07/23/2011 12:58PM
Re: Will it fit? 515 little doug 07/23/2011 03:38PM
Re: Will it fit? 381 Gordo 07/24/2011 09:28AM
Re: Will it fit? 589 little doug 07/24/2011 09:42AM
Re: Will it fit? 460 Gordo 07/24/2011 10:11AM
Re: Will it fit? 413 PwrWgnDrvr 07/24/2011 02:46PM
Re: Will it fit? 410 MoparNorm 07/24/2011 03:22PM
Re: Will it fit? 455 Gordo 07/24/2011 06:12PM
Re: Will it fit? 566 Gordo 07/29/2011 06:59PM
Re: Will it fit? 522 wideblock 07/25/2011 09:55AM
Re: Will it fit? 442 Gordo 07/26/2011 12:54PM


Array
Sorry, only registered users may post in this forum.
This forum powered by Phorum.