Re: Need some NP435 swap info
Posted by:
Dood
(71.231.157.---)
Posts: 7
Date: July 28, 2011 10:47PM
Steve, you rock! Thanks a ton for the photos.
I was thinking about swapping the 10 spline input shaft in my 435 for the shorter 23 spline shaft (which can be had new for ~ $70 + $5 for a new bearing). This was so that I could use the common 23 spline clutch disks. I've been told (by a trusted source) that I can use a 3 finger (B&B style pressure plate) in the hydraulic bell with this setup. I wonder if the 3/8 in. in the crank pilot bushing on the short shaft is enough.