Sweptline Showcase
Leave the loop. Many automotive manufacturers used a similar loop to lessen the effect of vibration and prevent the line from breaking. Just make sure that the line in the loop is not touching another section of the tubing, as that could cause a hole to wear into the tube.Quote
mike m
... Finally, the line that runs from my clutch master cylinder to the slave cylinder has a loop in it right before it bends down and goes vertical to the slave cylinder. Is this correct? I'm assuming the loop is there to help get rid of air when bleeding the system. I've never seen this loop before on other hydraulic clutch systems and wonder if it's really needed.
Thanks as always for your advice
Mike M